Pages: [1]
Author Topic: Buttons  (Read 4216 times)
burke
Newbie
*
Posts: 3


View Profile
« on: July 12, 2010, 12:38:54 PM »

Hi, I'm excited about my Arduinix build. I want to put together a timer (think kitchen timer) using 4 tubes. I want to include two push buttons into the build. One for setting the number of minutes and one for start/stop. Any ideas where I could interface the buttons on the Arduino?
Logged

cooper144
Newbie
*
Posts: 10


View Profile
« Reply #1 on: July 13, 2010, 08:24:59 PM »

You can use still use all of the analog pins, which may be configured, and used, in exactly the same manner as digital pins.
Logged

burke
Newbie
*
Posts: 3


View Profile
« Reply #2 on: July 15, 2010, 10:11:19 PM »

yes, thank you. Another question, for the right angle headers would the correct be 2 10 pin headers for the cathodes? I was thinking this header from Mouser:

http://www.mouser.com/ProductDetail/Molex/22-05-2101/?qs=sGAEpiMZZMtsLRyDR9nM13kGx0WjOXXXyJuQWjID3AQ%3d
Logged

Pages: [1]
Print
Jump to: