Robotpirate Forums

(http://www.nonentity.com/New/Images/Projects/Amp/AmpBoxFinishing2.jpg)

(http://www.nonentity.com/New/Images/Projects/Amp/AmpBatteryDoor.jpg)
Finally got my battery compartment in the mail! Had to cut the hard drive case, then arrange
the insides so that everything would fit just right.

(http://www.nonentity.com/New/Images/Projects/Amp/AmpBox_001.jpg)

(http://www.nonentity.com/New/Images/Projects/Amp/AmpBox_008.jpg)

(http://www.nonentity.com/New/Images/Projects/Amp/AmpBox_007.jpg)

(http://www.nonentity.com/New/Images/Projects/Amp/AmpBox_006.jpg)

(http://www.nonentity.com/New/Images/Projects/Amp/AmpBox_003.jpg)


(http://www.nonentity.com/New/Images/Projects/Amp/AmpBox_005.jpg)

It's a close fit!

(http://www.nonentity.com/New/Images/Projects/Amp/AmpBox_002.jpg)

Got the gain knob drilled and mounted, now for the Volume knob.


(http://www.nonentity.com/New/Images/Projects/Amp/AmpBox_004.jpg)

Knobs and line in jack assembled.


(http://www.nonentity.com/New/Images/Projects/Amp/HeadphoneJackWiring.jpg)

Wiring up the headphone jack this way lets me cut power to the
speaker when I plug in a set of headphones.


(http://www.nonentity.com/New/Images/Projects/Amp/AmpCircuit_001b.jpg)

Here is the bare circuit. Once I finish the housing, I'll trim wires to fit the layout a bit better.


(http://www.nonentity.com/New/Images/Projects/Amp/AmpBox_009.jpg)

Woo! Got the hole for the speaker set, and radiused. Not sure if I am going to leave it
Like this, or lathe out an aluminum bezel. Either way, the grille cloth I have on order
is going to cover the speaker when I'm done.


(http://www.nonentity.com/New/Images/Projects/Amp/AmpBoxFinishing1.jpg)

Several coats of high gloss tung oil, and a slightly enlarged speaker hole.  I also
widened the holes for the control knobs so they would turn more freely, instead of
binding on the smaller diameter hole.

beautiful.

it is possible view the schematics ?